Reliability
1 Cold test Storage (Low temperature storage life ) ----- 低温储存 条件：-40°C +/-2°C
2 Cold test operational (Low temperature Operating Life )----- 低温工作 条件： -20 +/-2°C
3 Damp heat storage (Humidity, high temperature storage life)----- 高温高湿储存 条件：T = 65°C+/-2°C H = 93 +2/-3% RH
4 Humidity, high temperature operating life----- 高温高湿工作 条件：T = 45°C +/- 2°C H = 93% +2/-3% RH
5 Power Temperature Cycling (PTMCL, TMCL)----- 温度循环测试 条件：T max= 45°C T min= -20°C (3hrs/30mins/3hrs) 最高温度停3小时，最低温度停3小时，中间温度变化半小时。 总时间：6.3hr/cycle
Environmental
REACH
1 ROHS
PVC/BFR free -----所有零件必须提供ROHS报告
Mechanical
1 Gauge test -----直径测试 T8 <28mm
2 Bending test ----- 弯曲度测试 4FT，5FT ≤3.5mm 2，3FT≤3mm
3 Torsion test ----- 扭矩测试 针对G13灯头，标准：1N*m
4 Pull and press test----- 推拉测试 针对G13灯头 标准：40N/min
5 Painting test----- 丝印测试 标准：IEC 60968 4.3
6 Size and dimention( IEC, ANSI) ----尺寸长度测试
7 Marking/Appearance -----外观检查
Electrical-- 电子的无须解释，根据设计做相应的测试
1 Inrush current
2 Line regulation
3 Load regulation
4 Output ripple
5 Short/Open circuit
6 Fast switching (4s on/1s off 50k cycles, with dummy starter)
7 Mains voltage increasing
8 Electric strength (Hi -pot test, 4KV, 60s, 10mA)
9 Radio disturbance - emission
10 Harmonic test
12 File test(input and output)
13 components V-I mapping
14 Excessive temperature of components close to plastic parts
15 ESD test
16 Power consumption
Optical
1 Integrating sphere test----- 积分球测试
2 Goniometer test (MBCP, Beam Angle)----- 分布光度计测试
Thermal
1 Thermal test ----- 测试一些重要零件的温度