The ADP1650 is a very compact, highly efficient, single white flash driver for high resolution camera phones that improves picture and video quality in low light environments. The device integrates a programmable 1.5 MHz or 3.0 MHz synchronous inductive boost converter, an I2C-compatible interface, and a 1500 mA current source. The high switching frequency enables the use of a tiny, 1 mm high, low cost, 1 H power inductor, and the current source permits LED cathode grounding for thermally enhanced, low EMI, and compact layouts.

The LED driver maximizes efficiency over the entire battery voltage range to maximize the input-power-to-LED-power conversion and minimize battery current draw during flash events. A programmable dc battery current limit safy maximizes LED current for all LED VF and battery voltage conditions.

Two independent TxMASK inputs permit the flash LED current and battery current to reduce quickly during a power amplifier current burst. The I2C-compatible interface enables the pro-grammability of timers, currents, and status bit readback for operation monitoring and safety control.

The ADP1650 comes in a compact 12-ball, 0.5 mm pitch package and operates within specification over the full ?40 C to +125 C junction temperature range.

ADP1650主要特性：

Ultracompact solution

Small, 2 mm 1.5 mm, 12-ball WLCSP package

Smallest footprint, 1 mm height, 1 H power inductor

LED current source for local LED grounding

Simplified routing to/from LED

Improved LED thermals

Synchronous 3 MHz PWM boost converter, no external diode

High efficiency: 90% peak

Reduces high levels of input battery current during flash

Limits battery current drain in torch mode

I2C programmable

Currents up to 1500 mA in flash mode for one LED with 7% accuracy over all conditions

Currents up to 200 mA in torch mode

Programmable dc battery current limit (4 settings)

Programmable flash timer up to 1600 ms

Low VBAT mode to reduce LED current automatically

4-bit ADC for LED VF, die/LED temperature readback

Control

I2C-compatible control registers

External STROBE and torch input pins

2 transmitter mask (TxMASK) inputs

Safety

Thermal overload protection

Inductor fault detection

LED short-/open-circuit protection

ADP1650应用：

Camera-enabled cellular phones and smart phones

Digital still cameras, camcorders, and PDAs

图1。ADP1650功能方框图

ADP1650 评估板

The evaluation system is composed of a motherboard, daughter- board and LED sub-board. The motherboard provides the I2C signals from the PC USB port and generates the I/O voltages and digital high and low signals for the daughterboard. For over-temperature measurement, the daughterboard can either be plugged directly into the motherboard or connected to the motherboard via a ribbon cable. The motherboard features a 3.3 V regulator and 2.8 V/1.8 V regulators for VDDIO. The daughterboard contains jumpers and test points for easy evaluation of the flash driver IC. Operating details are provided in the ADP1650 data sheet. The ADP1650 data sheet should be consulted in conjunction with this evaluation board user guide. Figure 1 shows the contents of the ADP1650

ADP1650评估板主要特性：

Input voltage: 2.7 V to 5.0 V

Evaluates single LED flash driver performance

I2C interface

Jumpers for measurement of flash LED current and supply current

Evaluation software CD with measurement report included

图2。ADP1650评估板外形图

图3。ADP1650评估板主板电路图

图4。ADP1650评估板子板电路图

图5。ADP1650 LED子板电路图

图6。ADP1650-EVALZ电路图

ADP1650评估板材料清单（BOM）：